Clik here to view.
PXI 4072 DMM initialization problem for repeated measurements
Dear NI Community, I am currently involved in a project where we work with a PXI 4072 for 2-wire and 4-wire measurements and I encountered an issue which heavily influences the execution time of the...
View ArticleI have got some errors for my PXIe-5450
Hello, I currently trying to test my PXIe 5450 module. I have installed Labview, NI Max, NIFGEN version 14 and also I have updated the firmware upto 1.1.1f4 for 5450 module. The module can be seen on...
View ArticlePxi8108 in Pxi-1010 chassis power led blinking no boot
Hi all I'm new here so please bear with me. i need help i just acquired a used pxi 8108 and have removed a working pxi-8156b from a pxi-1010 chassis when powering up he will not boot and the power led...
View ArticleWhich (USB-) chassi is compatible with the NI PXI-4072
Good morning dear forum members,I have the task to measure the physical capacity.Here is think the measurement card"NI PXI-4072"would beeffective.Now I wanted to ask whatChassi i need. The chassis must...
View ArticlePXIe 8108 GPIB driver
I recently had to reinstall Windows onto my PXIe 8108 crate controller, it's now running Windows 7 x64. Thus far I've managed to get most of the drivers for the various devices, but the GPIB driver is...
View ArticlePXI-4130 - no output on Ch1, fully functioning Ch. 0
Hello, My PXI-4130 just came back from calibration and now my Channel 1 does not provide any output. The PXI-4130 is running inside of a PXIe-8108 embedded controller and when I use the NI soft panel...
View ArticleAccess to calibration procedures
How do I get access to manual calibration procedures for PMI5411 and PXI4060 etc.
View Articletrigger using 1422
Hello Experts, I have PCI 1422 board which I am using for image acquisition, however now I also need to setup the trigger with one of the light source. So, basically I need to know how to setup the...
View ArticleHow can I do frequency hopping using RFSA and RFSG
Hello, I am a newbie in Labview, and I am currently trying to implement frequency hopping in Labview. I combine OFDM ( i got the example from here https://decibel.ni.com/content/docs/DOC-34781 ) with...
View ArticleProblem sending software trigger through PXI backplane (PXIe-1082 Chassis,...
Dear community, I am trying to implement a (software) PXI backplane trigger on a NI PXIe-1082 chassis with LabView 2015 (32bit) running on a PXIe-8135: - HS-DIO (PXIe-6544) in slot 2,- DAQ (PXIe-6363)...
View Articlepxie 8135 not visiable in MAX
hello initally i had the pxie connected to my pc successfully, however a week ago the pxie was deleted from the remote devices section of max. since then i cannot refind it by pressing refresh. i have...
View Articledatarate measurement of 5781 adapter module
Can anybody guide me how to measure datarate of PXI having NI-5781 adapter module.
View ArticlePXI-4110 Using Soft Front Panel on CH1 and CH2, cannot adjust current past...
Probably a very stupid question, but I cannot find anything in any manual about this. Using the soft front panel on the PXI-4011, on the 1A Range, the soft panel will not allow me to adjust the...
View ArticleGenerate trigger after DAQmx AI Voltage Acquisition is complete and send to...
Dear all, I would like to issue a trigger for a specific event to the PXI backplane (PXI Trigger Line 0..7) to other modules using a NI PXIe-6363 DAQ in a NI PXIe-1082 chassis. However there are two...
View ArticleNI PXIe-8108 not working
Hello, I bought on the Internet controller PXIe-8108 on the Internet and it turned out to be broken. Externally, there is no damage, but it does not work in any case. The controller does not run and...
View ArticlePXI-2503 Relay's
Hiknows anyone the related K-Relay Numbers of the CHannels- Relais? I can't find it in the documentation. ThxWolfgang
View Article779157-01 alignment pin??
Does this connector have an alignment pin? The supplied drawing shows that there is an option of having no pin, circlular pin, crush pin, or a diamond pin. Which one is it?
View ArticleSpanning multiple FPGA ports
I have a PXIe-7820R FPGA. The code I'm running was written for a 7813R, which has a different number of pins/channels. This means that I've had to reassign some of the I/O's such that I'm now using...
View ArticleClik here to view.
PXI Rack unknown device in Win 7 Device Manager
I am dealing with a flakey PC which only became flakey recently, and I am not sure why... The problem I am seeing is the PXI Rack is an unknown device in Win 7 Device Manager.Is there some sort of...
View Articlert8145 set date
I have PXI8145RT and Labview 7. After years of use, the system lost its system date. I have replaced the on-board battery (time keeper) but still when the get date/time function is invoked I get the...
View Article