Is there a USB alternative to NI PXI-8331 9-pin COM port
I am using NI PXI-8331 which communicates through 9 pin COM port . I need to know if there is USB alternative to this COM port which i could directly connect to my laptop (Win 7) which makes my work...
View ArticleClik here to view.
Stepper motor moving at 0 velocity every 16,4 seconds
HiI hope i post this topic in the good section, if not please tell me where is the best place to post it Here is the hardware we are using:- PXI-1033 updated firmware- PXI-7330 updated firmware-...
View ArticlePXIEe-1085 control of PCIe card
We have a PXIe-1085 chassis with a PXIe-8135 embedded controller and are looking at a third party peripheral card that only comes in a PCIe form factor. I understand that the bus structure is very...
View ArticleInvalid Resource Name Error from the NI
Hi team, I am trying to connect my system with the NI PXI 8331 MXI-4 . I have developed an application in C Language using the NI Drivers that accesses/communicates to the NI box. But at the...
View ArticleHow to close all open session of PXIe
I am using PXIe 6674T timing and sync. module.How to close all open session?
View ArticleNI6587 using DCM not correctly detect clock
HI. I have module NI6587 (PXIe-7962). I created my personal socketed clip using clip (NI6587DCM.ZIP) for NI6587 Connector Serdes but instead RegionalClockBuf (in Timing Engine.vhd) I use DCM_ADV...
View Articlefpga
Hello, I am currrently working on the PXIe-7962R to perform several DC to DC conversion control. I have seen a presentation on your website that has an example that is somehow similar to my...
View ArticlePXI_Add AWGN to a carrier generated using NI RFSG in Arbitrary Waveform mode
Hello ! Does anyone know how to add AWGN to a carrier generated using NI RFSG ?I know how to generate a CW signal using NI RFSG in Arbitrary Waveform mode (please see the attached file), but I have...
View ArticleProgrammatically find if Chassis is using external 10 MHz (1085)
Hi all, Is there any way for me to remotely determine if my PXIe chassis (1085) has locked on to the external reference I feed into its 10 MHz IN connection? The manual states this is done...
View ArticlePXI Chasis is whistling
An older 6-slot PXI Chassis (NI PXI-1036DC) that we have just started making a whistling sound. Is the fan going bad? Any ideas?
View Article[FlexRIO adapter module] unknown I/O module (NI5791)
Hi!I recently reinstalled LabVIEW 2013 and MAX 5.5 together with all other device drivers after an update failure. I am using FlexRIO 7961R with NI5791, and after the reinstallation, the FAM is no...
View ArticleTesting the 4110 in Cal Exec 3.6
We are trying to get rid of our XP computers so upgraded Cal Exec from 3.4.1 at the same time. The new 4110 test has 4 added sections. There is no README file so I am stumbling through. First, I...
View ArticlePXI Chassis Not Recognized Correctly in MAX
Hi, i have an ADlink pxis-2670 14 slot chassis and NI pxi-8110 controller that do not seem to identify properly in max. I have the latest chassis and controller ini files installed but when i identify...
View ArticleTry to install software on RT PXI 1082 target
Hi, I try to run a PXI-1082 chassis (Recovered with Factory parameters) but I have some troubles when I try to install softawre on it via NI-MAX from another PC connected with ethernet cable.First, I...
View ArticlePXI-MXI chassis times out only in MAX
Hi all, I am using a PXIe-1062Q chassis, connected to my laptop via a PXIe-8361 and the MXI express card. Recently, on opening of MAX, the system times out and an X is shown on the PXI chassis. This...
View ArticlePXI SYSTEM DETECTED AS NI-GenericDesktopPC IN MAX
Hi All, We are trying to configure our system for FPGA programming . But something is a little strange. When I open MAX from HOST computer, my PXI is not listed under remote systems. Instead under...
View ArticlePXI-4496 vs PXI-4462 resolution
Is it possible that for a same voltange range, the PXI-4462 card has a lower resolution that the PXI-4496, even if they are both 24-bit?
View ArticleRead DC motor current using NI PXI-6254
Hello, I would like to measure the current in a DC motor. I placed a 1 ohm resistor in series with a DC motor. The current to my DC motor is controlled with an LDU-S1 which is a voltage controlled...
View ArticleWanted (dead or alive) PXIe Controller (or just the I/O board from it)
Stupid me--I bricked a PXIe-8105 Controller by installing the wrong firmware update! It was in a 1062Q chassis that was donated to our educational program for kids. Does anyone have controller or the...
View ArticlePXI: no devices (MAX), fail to connect or deploy
Hello, I have been trying to use a PXIe-8135 and according to MAX the status is "Connected - Running" but once I try to connect or deploy from the project it opens a dialog box saying "Fail to connect...
View Article